PASSABLENESS OF THE CAR

If the rack (shock-absorber) does not develop sufficient resistance at a release course, possible causes of defect can be:
ungermetical the valve of a release as a result of a contamination or damage of its details (to disassemble the valve to wash out it to replace the damaged details to filter or replace a liquid);
Reduction of effort of a spring of the valve of a release (to replace a spring or to adjust the valve to increase quantity of disks in the shock-absorber);
Working capacity infringement перепускного the valve (to restore working capacity the valve to replace the damaged details: the valve, a throttle disk, the piston, a spring); deterioration of details because of which the liquid overflowing on backlashes or deep risks of the worn out piston and its ring, the cylinder, a rod increases and directing (to replace the worn out details to replace a rod new or to repair).
If the rack (shock-absorber) does not develop sufficient resistance at a compression course, possible causes of defect can be:
ungermetical the valve of compression because of a contamination (to wash out the valve to filter or replace a liquid);
Deterioration of a working surface (to replace the worn out surfaces);
Deterioration, deformation or damage of details of the valve of compression or the inlet valve (to replace the valve of compression of a rack completely or only a saddle with the compression valve; to replace details of the inlet valve of a rack; small roughnesses of ring edges on the case of the valve of compression of a rack if выпрессовано a saddle, to eliminate grinding in on a plate or to replace the case; to disassemble the valve of compression of the shock-absorber and to replace the worn out or destroyed, damaged details).
If the rack (shock-absorber) develops the big resistance in the end of a course of compression, the superfluous quantity of a liquid in a shock-absorber rack can be a possible cause of defect. The superfluous liquid should be removed. When in a rack (shock-absorber) at sharp moving of a rod knocks easing of an inhaling of a nut of the tank or piston fastening can be the possible reason of their occurrence are observed. It is necessary to tighten a tank or piston nut. At insufficient quantity of an amortisation liquid it is necessary to check up volume of a liquid and to finish it to the normal. If in a rack (shock-absorber) jammings at rod moving bends of a rod can be the possible reasons, damages of the working cylinder (to replace a rod and also to replace the cylinder) are observed.